UNMANNED TECH
  • Home
  • Shop
  • Students/Researchers
  • About

Gimbal Director Connection Guide

21/4/2014

Comments

 
DYS Gimbal Director
The gimbal director is essentially a D-pad that outputs direction commands to your brushless gimbal controller allowing you to control 2 axis stabilisation angles manually.  Ideal for use with handheld gimbals!
Buy Gimbal Director

Connecting the Gimbal Director

Picture
  • To connect your gimbal director you simply need to use the included 4 pin cable.
  • Connect the 3 pins to one CH  1 on the gimbal director board, and the single pin to the signal pin of CH 2
Gimbal Director Connection
  • Follow the diagram to attach the gimbal director module to your alexmos brushless gimbal controller.
  • As shown in the diagram you will need to connect the cables to the RC Pitch, and RC Roll channels on the alexmos board
  • Once its all connected you just need to enable the joystick settings via the simpleBGC GUI program and assign the 2 channels to the function you require.
If you have any questions or problems please ask us here
Comments
comments powered by Disqus

    Categories

    All
    Camera
    ESC
    Flight Controller
    Fpv Gear
    Gimbals
    Gluonpilot
    Multirotor
    Radio Control
    Telemetry

    RSS Feed

    Forums
    Buy Stuff
    Knowledge Base
Picture
Visit our Community Forums if you have any questions
  • Home
  • Shop
  • Students/Researchers
  • About