5.8Ghz Multi Band FPV Transmitter Manual

Our Multi-Band FPV transmitters are able to operate across the 5.8Ghz spectrum which makes them compatible with almost all the FPV gear on the market, including fatshark headsets!

Our 200mw TX (TX5802) is the full 32 Channel version, and your 25mW TX (TX58025) is limited 21 Channels to keep it license free. 

Buy FPV Transmitter

Connection Diagram

Frequency Table (200mw version)

Frequency Table (25mw Version)

Selecting a Channel

• Connect Transmitter according to the schematics above. After powering on the transmitter, “LED display” will show the initial channel number.
  
• By quick pressing “Channel button”  the channel number will change. While pressing button the channel number will increase in order of 1,2,3,4,5,6,7,8.  “LED display” will show current channel number.

Selecting a Frequency Band

• By long pressing the “Channel button” you will enter frequency band setup mode, “LED display” will show the current frequency band, and the icon will lights up permanently; at this moment, each quick pressing on “Channel button”, the frequency band will change in order of A,B,E,F, Long pressing on “Channel button” again, it will quit from frequency band setup mode and the frequency is also be changed.
  
• If you want to check the current working frequency band, please long press “Channel button”. Once again long pressing “Channel button” to quit menu
  

Important Notes

• After performing frequency band setup please ensure you exit this mode properly (by long pressing the button), otherwise the new frequency will not be set.
• The unit will save current channel while changing and power off so you don't need to set it each time