UNMANNED TECH
  • Home
  • Shop
  • Students/Researchers
  • About

M450 QUADCOPTER FRAME ASSEMBLY GUIDE

18/9/2012

Comments

 
Picture
The M450 quadcopter frame includes adustable landing gear so you can adjust the height depending on what you are carrying underneath.  The weight fo the frame is about 350g excluding any electronics.  The motor to motor distance is 450mm.  The frame is made from high quality 1.6mm fibreglass plates 

Important Safety Notes

Please make sure you read our Multicopter Safety Notes page as it has some important tips to keep you and people around you safe when flying your multicopter.

About Your Frame

Picture
Picture

Parts List for M450 Quadcopter Frame

Picture

Arm Assembly

Picture
Picture
  • Attach the nylon hex spacers to the arm plate using the M3 screws as shown
Picture
Picture
  • Now you need to attach the landing gear leg to the arm as shown
Picture
Picture
  • Now you need to attach the other side of the arm, and also the motor mount.  
  • Take note of the motor mount orientation!  With the square hole for the motor cables.
Picture
  • Repeat this for all 4 quadcopter arms

Central Frame Assembly

Picture
  • Using the Nylon Hex Spacers and the M3x6mm screws, attach them onto the central plate as shown
Picture
Picture
  • You will now need to attach the legs to the central frame of your quadcopter frame as shown in the image
Picture
Attaching the top plate - click for full view
Picture
  • The last step is to secure the legs to the central frame by attaching the top plate and securing it with the remaining M3x6mm screws.
If you have any questions or comments please ask below.
Comments
comments powered by Disqus

    Categories

    All
    Camera
    ESC
    Flight Controller
    Fpv Gear
    Gimbals
    Gluonpilot
    Multirotor
    Radio Control
    Telemetry

    RSS Feed

    Forums
    Buy Stuff
    Knowledge Base
Picture
Visit our Community Forums if you have any questions
  • Home
  • Shop
  • Students/Researchers
  • About