UNMANNED TECH
  • Home
  • Shop
  • Students/Researchers
  • About

M200 Landing Gear Assembly Guide

7/7/2014

Comments

 
Picture
The M200 Landing gear are compatible with most quadcopter frames like the F450/F550 and also our G680 and H680 frames.  This guide will show you how to build and attach them to your quadcopter.
Buy M200 Landing Gear
Picture
  • The first step is to attach the ircular Clamps onto the 12mm Glass Fiber Pipe as shown
Picture
  • Attach the 8mm glass fiber pipes onto the bottom on the plastic landing gear frame as shown
Be careful not to force the plastic clip to hard as you dont want to snap it off!
Picture
  • Insert the 12mm Pipe into the top clips of the plastic Leg Frame
Picture
  • Now you will need to adjust the tube clips according to the frame you plan to mount them on.
Picture
Picture
  • Follow the frame guides as shown below with the red circles showing the locations to mount the legs
  • Use the M2.5 screws and nuts to secure the clamps to your frame plate
Picture
Picture
  • Assuming you followed the instructions correctly, your landing gear should look similar to what is shown.
  • If you have any questions or problems please let us know on Dronetrest.com
Comments
comments powered by Disqus

    Categories

    All
    Camera
    ESC
    Flight Controller
    Fpv Gear
    Gimbals
    Gluonpilot
    Multirotor
    Radio Control
    Telemetry

    RSS Feed

    Forums
    Buy Stuff
    Knowledge Base
Picture
Visit our Community Forums if you have any questions
  • Home
  • Shop
  • Students/Researchers
  • About