Lumenier LUX Flight Controller (Manual and more)

​The LUX flight controller from Lumenier is here! ​This is the flight controller that provides gyro refresh rates of up to 8kHz using Betaflight and Raceflight. This flight controller comes with CleanFlight pre-installed and uses the powerful F3 processor.

Read more for the specs and the manuals. 

Buy Now

The Lumenier LUX User Manual:

lux-lite-manual.compressed.pdf
File Size:	1063 kb
File Type:	pdf

Download File

---

HARDWARE FEATURES:

• USB Conflict resolution - Hardware inversion, SBUS or telemetry can be used on any of the 3 available hardware serial ports. USB will not interfere with peripherals.
• High Speed SPI 8kHz Gyro
• MPU interrupt connected to F3, allowing the F3 to know immediately when fresh data is available.
• Dedicated Boot button for easy firmware flashing.
• Reinforced solder pads for trouble-free direct soldering.
• Extremely low profile design.
• Recessed, sideways pin headers. Also enables soldering of all wires directly to pads without use of any pin headers.
• Integrated FRSky RSSI Filter (RC filter).
• Input voltage 6v to 24v. Power the board directly from flight pack up to 6S (on 'BAT' pad only!).
• VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.
• Filtered voltage output - output 5v 1A (and 3.3v where applicable) to power peripherals such as GPS, RX, BLACKBOX, OSD. 5v/3.3v RX selectable.

SOFTWARE/HARDWARE FEATURES:

• Cleanflight support (RACE target).
• BLHeli flashing supported by hardware 
• Raceflight ready
• Betaflight ready

SPECIFICATIONS:

• STM32F303RCT6(256kB flash) 32-bit processor
• MPU6500 Gyro/Accelerometer
• High quality, gold plated PCB
• Highest quality components, individually sourced to meet Lumenier standards
• Micro USB connector for programming
• Dimensions: 36x36x6mm (includes USB in height)
• Mounting Holes: 30.5mm square to center of holes 
• Weight: 6g