UNMANNED TECH
  • Home
  • Shop
  • Students/Researchers
  • About

ArduPilot Mega 2.5 Case assembly tips

14/12/2012

Comments

 
Picture
The new APM 2.5 enclosure, available in both top pin and side pin styles. It's designed to keep your electronics safe while looking great at the same time! The enclosure is made of black translucent ABS plastic so you can see the board's LEDs. It protects your electronics while allowing access to all pins and connectors. The inside of the enclosure is lined with ESD safe open cell foam to ensure the barometric pressure sensor is surrounded by static air and prevent unwanted readings due to airflow over the sensor. And the screws that secure the enclosure have been moved to the top for ease of use.

Top Entry Case

Picture
The top pins APM 2.5 enclosure contains the following:
  • *Enclosure
  • *M2x7mm x3
  • *M2x11mm x1
  • *Foam
Picture
  • Remove the backing from  the foam and adhere to the top part of the enclosure as shown
  • Make sure the foam is right up against the APM Inputs. 
  • Place the reset button in the Reset hole as shown.
Picture
  • Place your APM 2.5 over the top of the enclosure.
  • Place the bottom of the enclosure over your APM 2.5 . 
  • Note: Make sure the USB and GPS line up with the grooves on the bottom part of the enclosure.
Picture
Picture
  • Turn over and secure the enclosure using the four M2 screws provided. 
  • Note: the longer screw goes on the top right corner.

Side Entry Case

Picture
The side pins APM 2.5 enclosure contains the following:
  • *Enclosure
  • *M2x7mm x3
  • *M2x11mm x1
  • *M3x3mm x4
  • *Rubber 
  • Washer x4
  • *Foam
Picture
  • Secure the APM 2.5 board to the bottom of the enclosure using the four M3 screws and rubber washers. 
  • Note: Make sure the USB and GPS connectors line up with the grooves in the bottom part of the enclosure.
Picture
  • Remove the backing from the foam and adhere to the top part of the enclosure as shown.
  • Make sure the foam is right up against the APM Inputs.
  • Place the reset button in theReset hole as shown
Picture
  • Place the bottom part of the enclosure and APM25 over the top part of the enclosure as shown.
Picture
  • Turn over and secure the enclosure using the four M2 screws provided. Note: the longer screw goes on the top right corner.
Picture
Picture
Picture
Comments
comments powered by Disqus

    Categories

    All
    Camera
    ESC
    Flight Controller
    Fpv Gear
    Gimbals
    Gluonpilot
    Multirotor
    Radio Control
    Telemetry

    RSS Feed

    Forums
    Buy Stuff
    Knowledge Base
Picture
Visit our Community Forums if you have any questions
  • Home
  • Shop
  • Students/Researchers
  • About